Waching daily Nov 8 2018

Hi everyone! With you Catherine and Obustroeno

And today we finish our panel with succulents.

The basis of the panel will be such a box of 20x20 cm

The backlight will be LED strip, I took 1 m

This is a LED strip that can be connected to the network.

We will need: 1) box 20x20 cm; 2) LED strip; 3) polystyrene; 4) acrylic paint in 2 colors; 5) a candle; 6) Heat gun; 7) double-sided tape

To LED tape need a design that will allow you to connect it to the network

Drill a hole so that we entered into it that part, which will be attached to the LED strip

I'll show you what it will look like.

In the future we will fix it all.

And we will fix the LED tape on the sides of our panel

According to this principle, stick it on the double-sided tape

Before that you need to decorate the box

You can just paint it white, but I'll make a little scuff

I have some coral paint left

First, we paint it in the color in which our scuffs will be painted.

I will have these

We also need a candle and white paint, which will be the main

This is ordinary acrylic paint.

Apply to the place where there will be scuffs

No need to paint inside, there will be LED strip and succulents

So that the paint does not paint the hands, dry it with a heat gun

Rub the places where we should get scuffed with a regular candle

Most often they occur on the ribs

Now painted in the basic color, mine is white

Once painted in white, you can no longer blow dry with a heat gun

Otherwise paraffin will melt and scuffs will not work.

We pass through the places that were treated with a candle, using the hard side of the sponge

We attach a LED tape

Check

Glue the LED tape. Only not at the bottom, but at the top

Below will be a piece of polystyrene, in which we will insert succulents.

If you are afraid that the LED tape will pop out, stick it with scotch tape.

We insert polystyrene into the box

We insert so that it does not close the LED strip

Glue on hot glue

We begin to set succulents

The most beautiful is better to put in the center

Place around the succulent immediately covered with decorative pebbles.

Glue it on hot glue

Cacti will bulge a bit. Therefore, first make a small hole for them and only then insert

If your LED strip is long, you can wrap it inside.

Done

Turn on

Here is a panel with lights turned out